World’s First Electrically Connected Pistol and Laser
This is also the first pistol laser designed to fit like a glove on the Glock 17 and 19. The beautiful design looks like it came out of the mold with the pistol. All other pistol lasers are made to fit all pistols, therefore they don’t fit any very well.
The Basic Pistol Laser has two switches for activation. The yellow “Primary” switch turns the laser ON and OFF, just like any other laser.
The laser and the frame are connected via three gold pins at the rear of the laser, and three gold contact points at the front of the trigger guard. The Laser powers the sensor embedded in the frame, which provides a signal to the laser at the appropriate time.
The laser will power the sensor for years without degrading the laser’s batteries. Laser burn time is approximately 2 hours for green, 10 hours for Infra Red.
The frame components must be installed by our professional staff. We can turn the pistol frame around in about 48 hours and since it is a gunsmithing operation, no FFL transfer is involved. The frame components have an unlimited life expectancy and an unconditional warranty for the life of the laser.
No moving parts of the weapon are altered in any way. No components are installed inside the weapon. Everything is inside the trigger guard.
Once you get your pistol back, all you will be able to see are three tiny gold dots on the front of the trigger guard.
Trigger Safety Activation of Flashing Laser
Once the laser is manually turned ON, the trigger safety now becomes “Hot”.
When the decision to shoot the weapon has been made, the finger moves inside the triggerguard. .
When the trigger finger touches the trigger safety with enough pressure to actually feel it, about one ounce, the trigger safety spur begins to retract. When the trigger safety spur has partially retracted about one millimeter, the sensor activates the flashing laser mode and causes the laser to flash about 8 times a second.
A flashing laser means your finger is on the trigger. It is the World’s first visual trigger safety.
This photo shows the actual position of the trigger safety when the laser changes from solid to flashing
This flashing mode will continue as long as the finger remains on the trigger safety. Removal of the finger from the trigger safety causes the laser to revert to a solid green laser.
The yellow primary switch must be used to turn the laser off.
In order to fire the weapon, you need to increase the pressure on your trigger finger 80 to 100 times to pull the trigger to discharge.
After the laser is manually turned on, inadvertent or unconscious trigger finger placement onto the trigger will cause the laser to flash and will act as a safety device indicating to the holder of the firearm that the weapon is being prepped to fire.
As always, the third rule of safe gun handling states: Never touch the trigger until you are ready to shoot.
The trigger safety activation switch is not intended to be used as a substitute for proper weapon handling.
The Laser uses new second generation direct green diode technology capable of operating down to zero degrees fahrenheit. The laser also uses threaded bosses for each screw so screws will not strip out. Weapon light can be attached to bottom of laser on the laser’s small picatinny.
Price of the laser is targeted at $300, price of the frame enhancement is targeted at $150
Production expected to begin 1st quarter 2016
Demonstration and Training of the Gen III Glock Laser can be arranged by contacting:
Hammer Stryke Self-Reliance Training, Inc
5170 Echo Hill Dr
Mariposa, CA 95338